2002Stock.jpg (43026 bytes)



Site Links:
Site News
Guru's Prior Blog's
VMax Files
Submitted Bikes

Gen 1 120(+) RWHP Club

Gen 2 200(+) RWHP Club

Jay Gleason




Roy Tanck's Flickr Widget requires Flash Player 9 or better.

Get this and other widgets at roytanck.com


Site Hits

Hit Counter

This site was created and maintained by:
Tim Nash


Copyright 2010
All rights reserved.



ABS Test Jumper

5/31/09 Here is how to install a jumper in the ABS test connector found under the left side cover.


Take ignition key and remove left side cover


Remove protective end cap from test connector:


Locate the black and green with yellow stripe wires.


Install jumper between these two wires.


Here is a photo of the jumper installed.


Turn on ignition and diagnostic and fault codes appear on the display.


In this mode, there are a lot of test for the ABS system covered in the Service Manual.